Free tool
Slope Calculator
A field reference for percent grade, degrees and slope ratio (H:V), in feet or meters.
Measurements
Positive = upslope, negative = downslope
Result
How to calculate slope
Rise over run gives the slope: divide the rise by the run and multiply by 100 for percent grade, so a 10 ft rise over 100 ft of run is a 10% grade. The angle in degrees is the arctangent of rise over run, so a 10% grade is about 5.7 degrees and 100% is 45 degrees. Use the same unit for rise and run.
% grade = rise ÷ run × 100
degrees = arctan(rise ÷ run)
SiteFacts
Email me these results
Get a copy of this calculation in your inbox, so you can keep it with the job file or send it to the customer. Someone from SiteFacts may follow up.
Slope questions
How do I convert slope percentage to degrees?
What is a 2:1 or 3:1 slope?
How do I calculate slope percentage?
How much should the grade slope away from a foundation?
What is the maximum slope for a driveway?
Related reading and tools
Guide
Cut and Fill Risks
How older cut and fill site prep can hide risks for a new build.
Guide
Grading and Drainage Requirements
An overview of grading and drainage requirements for new construction.
Guide
Geotechnical Report Cost
A look at geotechnical reports and their cost for residential construction.
Guide
Fire Truck Access Rules
Driveway width and the 150 foot fire truck rule, where fire codes adopt it.
Tool
Excavation and Fill Calculator
Work out balanced dig depth, dirt to import or export, and truck loads.
Tool
Pipe Slope Calculator
For pipe slope instead, calculate total drop, end depth and slope for drain runs.
About this tool
The SiteFacts Slope Calculator is a slope percentage calculator that turns two elevations, or one change in elevation, plus the horizontal run into percent grade, angle in degrees and slope ratio (H:V), in feet or meters. Use it as a quick reference on a grading plan, a driveway, slope for drainage or a cut or fill slope, and the math is exact for the numbers you enter.
It does not know the customer’s lot, and it does not check zoning, site grading rules, soils, retaining wall or stepped foundation requirements, or what the jurisdiction allows. Those rules vary by jurisdiction and can come from the state, county or city, so confirm with the local building department. To see the actual parcel, search the address on the free SiteFacts map or use the SiteFacts App, and use SiteScore when the customer needs it in writing.